Emmen
Emmen
Celle
Aberdeen
+31 591 667 687 Mon - Fri 08:00 - 17:00 Karel Doormanstraat 4, Emmen, Netherlands
+49 5141 82033 Mon - Fri 08:00 - 17:00 Bruckampweg 28, Celle, Germany
+31 591 667 687 Mon - Fri 08:00 - 17:00 28 Abercrombie Court, Westhill, Aberdeen
Certified
ISO:9001 / 14001 / 45001
Experienced
21 years experience
Proven track-record
700+ wells restored
Contact us

Category

Engineering

NUI Workover

The platform was a gas producer and was located in the Southern UKCS. Normally it is an unmanned installation (NUI) and as such had significant restrictions in terms of available beds, deck space and crane limitations. The objective was to workover a gas producer that had proven communication between the tubing and annulus. BPC were […]

Coil Tubing Recovery

/ / /
The platform was located on a Large Gas Producing Field in the Central North Sea. The Wells were beginning to water out and in an attempt to increase production the decision was made to run Coil Tubing Velocity Strings. During the first string installation a runaway occurred which resulted in the shear seals being closed […]

LIVE WELL CONNECTOR

/ / /
Four existing multi-lateral horizontal gas wells located in the Southern North Sea were initially completed barefoot but production eventually ceased due to blockage of the production conduit by reservoir solids (sand and rocks). To mitigate this problem, 2-7/8” pre-drilled liner pipe made up in lengths of up to 200m was to be deployed on wireline […]

HPHT UBD

The platform was a HPHT gas condensate producer in the Central North Sea. A Well had been suspended with a shallow cement plug and was to be abandoned. Bellow the cement plug was the possibility of 800 bar. The objective was to rig up a snubbing unit within the derrick of a jack up, then […]

ESP Workover

The platform was located on an Oil and Gas Producing Field in the Irish Sea. The Oil producing Wells no longer free flow, thus an ESP is used to lift the oil. As with all electrical motors, ESP´s also have a limited life span. When a failure is encountered the solution often involves a full […]

Live well Coiled Tubing Recovery

/ / /
This gas injector/producer well was drilled in 2014 to a depth of 2635 mAH. After the well was completed and tested, coiled tubing was used to retrieve a 5.75” RPT standing valve installed in the packer tailpipe. Pressure differential over the valve was equalized using nitrogen. Coiled tubing was not able to free the valve. […]

Offshore P&A – HWU and Liftboat

The platform is located in the German part of the North Sea in shallow water. The platform supports a single 3200m deep gas production well which was drilled and completed in 1991. The objective was to Plug & Abandon this single gas production well and to remove the surface casing, conductor and wellhead.

Re-Abandonment

The well was drilled in 2012 to a depth of 2635m AH and was found dry. The 13-3/8” and 9-5/8” casing-shoes were set at 564m and 1295m respectively. The well was permanently abandoned by means of 5 cement plugs. The 9-5/8” production casing was cut and retrieved from 600m creating a uncased hole section of […]
1 2